Vanquish Products Machined Rod Ends, Straight M4, Black

About this part

Machined M4 rod ends from Vanquish Products in black. They are a rebuildable alternative to molded rod ends, and use the same design approach as the machined trailing arms. An adjustable tension system holds the pivot ball in the rod end without a pressed fit. An M2.5 set screw presses on a brass tension piece, so you can re-tension it as parts wear. They replace Incision rod ends IRC00010 without changing the overall link length.

You will receive

• 4 machined rod ends
• 4 brass tension set pieces
• 4 M2.5 set screws (0.05in driver required)
• 4 pivot balls
• 1 instruction sheet

Notes

• Machined rod ends are assembled differently from molded ones, so they may not cinch down and may rotate slightly once installed.
• Use a small amount of threadlock on the M2.5 set screw. Too much can make it hard to remove.
• No threadlock is needed on the M4 threads when installing onto the link.
• Assembly takes patience because of the small parts.
• FITS: Axial SCX-10 II, Axial SCX-10 II RTR, Axial SCX-10 II Deadbolt, Traxxas TRX-4 1:10 scale & trail crawler, HPI Electric Venture FJ Cruiser, Cross RC SG-4 4x4 Demon

Fits