Exotek RC10 Hd Adjustable Rear Hubs, 7075, for M3 Ball Studs

About this part

Precision-machined 7075 aluminum rear hubs for the RC10 Classic buggy series, including the RC10T and RC10 4WD. The bearing pockets are re-machined for a precise fit with the stock bearings, and the bearing surfaces are left unanodized. Adjustable roll center mounts and camber gain come from M3 washers used with the angled ball stud mount, which the stock hubs cannot offer. High and low roll center positions for the lower hinge pin are included, along with M3 set screws to pin the hinge pins.

Note

• These hubs require metric ball studs such as Associated ASC91047. Do not use the weaker stock 4/40 ball studs.
• TIP: Use with Associated RC10 4WD ball cups and turnbuckles ASC6535 and ASC6547.
• Fits: general hobby, universal fit car parts

Fits